TCT-MZ
Technical data
Doc: 70-00-0588 V1.0, 20180928
© Vector Controls GmbH, Switzerland
Page 3
Subject to alteration
www.vectorcontrols.com
Installation and Safety advice
Caution!
This device is intended to be used for comfort applications. Where a device failure endangers human life and/or
property, it is the responsibility of the owner, designer and installer to add additional safety devices to prevent or detect a
system failure caused by such a device failure. Vector Controls or its affiliates cannot be held liable for any damage
caused by such a failure. Failure to follow specifications and local regulations may endanger life, cause equipment damage
and void warranty.
Connection diagram
Description:
G0
Power supply:
0V, -24VDC, internally connected to signal common
G
Power supply:
24VAC, +24VDC
M
Signal common:
Common 0 potential for analog inputs and analog outputs.
X1
External passive input:
open contact to signal common
U1
Analog output supply air:
0…10 V DC
U2
Analog output return air:
0…10 V DC
Mounting location
On an easy accessible interior wall, approx. 1.5 m (4.5’) above the floor in an area of average temperature.
Avoid exposure to direct sunlight
Installation
Install on an easy accessible interior wall, approx. 1.5 m (4.5’) above the floor. Installation only on an on-wall or under-
wall box (frame and mounting plate is not included)
Installation:
1.
Connect the wires to be connected to the terminals of the power case according to wiring diagram
2.
Install the mounting plate to the flush mounting box
3.
Screw the power case to the metal plate. Connectors need to point upwards!
4.
Place the frame on mounting plate and hold it with one hand
5.
Take the display and place it in the middle of the frame, the thick side of the display frame need to point
downwards
6.
Verify that the 10 pin connector connects correctly
7.
Carefully press the display on the power part until the clamps are clicking in (it may be required to move the
frame slightly).
0V (COM)
24V AC/DC
2
G
TCT-MZ2
1
G0
3
U1
Supply
OUT
4
U2
Return
OUT
7
M
Signal
COM
5
X1
X
1
IN
