Vectaire ELIX 1003, Installation And Operating Instructions Manual

Page: 3 / 10

WARNING: Damage could be caused to the product
if the installation instructions are not followed.
• The product should not be used in an ambient
temperature higher than 40°C (104°F).
• The product should not be exposed to atmospheric
agents (rain, sun, snow, etc.).
• The product or its parts should not be placed in
water or other liquids.
• Routine maintenance as described below should
be carried out to check the condition of the fan.
• The air or fumes being extracted must be clean
and free from greasy particles, soot, chemical and
corrosive agents, flammable or explosive mixtures.
• The product must be installed by professionally
qualified personnel. Incorrect installation can
cause damage to people, animals or property,
for which the manufacturer cannot be held
liable.
• The product must be connected to the electricity
supply via a double pole switch of a suitable size,
with contact openings of at least 3 mm.
• If the electrical supply board (or switching device)
is located some distance from the fan a means of
local isolation must be provided.
• To ensure optimum operation, do not block the
air intake and exit vents.
• Any ducting used must be free of blockages, and
should be insulated if in an unheated area.
• The room where the product is operating must
have adequate air replacement to ensure maxi-
mum effectiveness.
• If the product is sited in a room containing a fuel
burning appliance which is not of the balanced flue
type, the installer must ensure that air replace
ment is adequate both for the fan and the fuel
burning appliance
• The product must not be used as an activator
for water heaters, stoves, etc.
• The product must not exhaust into ducts
designed to evacuate fumes from combustion
in stoves or other combustion-powered devices.
RANGE
Trickle Speed 1 - 8 lt/sec - 28.8 m³/h
Trickle Speed 2 - 14 lt/sec - 50.4 m³/h
ELX1003
- this fan combines the latest technology
with energy saving and efficiency. It is a quiet run-
ning, 3 speed fan designed to run continuously at a
pre-selectable choice of 2 trickle speeds (see jumper
switch settings). The user can boost the fan speed
to its maximum performance when required by
means of the cord or remove the cord and use a
remote switch, light switch, PIR sensor or humidistat.
If the fan is to be ceiling mounted, the pull-cord
switch should be put in the “off” position and the
cord removed. A remote switch will be necessary
for changing the fan speed. See wiring diagrams.
The ELX1003 is SAP Appendix Q Listed
ELX1003DT - 3 speed, continuous running fan with
delay-on timer and pull cord. The delay-on timer ver-
sion will run at low speed until the boost speed
(speed 2) is activated by means of the cord or, if the
cord is removed, by means of a remote switch, light
switch, PIR sensor or humidistat. There is a 2
minute delay before the fan starts to run at its high
speed - if the boost speed is deactivated before that
time lapse, the fan will continue to run at low speed.
If the boost speed is activated, the fan will operate at
high speed until the boost switch is turned off. After
this, the fan will continue at high speed for the length
of time set on the timer overrun adjustment,
between 0 and 30 mins (see Trimmer Adjustment
diagram). After the overrun time has elapsed, the
fan will return to the slower speed.
4