Copyright © Vecow Co., Ltd. All Rights Reserved. SPC-2000 Series Ultra-compact Embedded System User
Manual
2.17
Main Board Jumper Settings
The figure below is the top view of the SPC-2000 main board which is the main board used
in the SPC-2000 Series system. It shows the location of the jumpers.
You may configure your card to match the needs of your application by setting jumpers. A jumper
is a metal bridge used to close an electric circuit. It consists of two metal pins and a small metal
clip (often protected by a plastic cover) that slides over the pins to connect them. To “close” a
jumper, you connect the pins with the clip. To “open” a jumper, you remove the clip. Sometimes a
jumper will have three pins, labeled 1, 2 and 3. In this case you would connect either pins 1 and 2,
or 2 and 3.
JP1
JP2
