Vecow ECS-9101, User Manual

Page: 55 / 122

48
GETTING TO KNOW YOUR ECS-9200/9100 ©Vecow ECS-9200/9100 User Manual
2.5 Main Board Jumper & Deep Switch Settings
2.5.1 Top View of ECS-9200/9100 With Jumper and DIP Switch
The figure below is the top view of ECS-9200/9100 main board which is the
main board. It shows the location of the jumpers and the switches.
You may configure your card to match the needs of your application by setting
jumpers. A jumper is a metal bridge used to close an electric circuit. It consists
of two metal pins and a small metal clip (often protected by a plastic cover) that
slides over the pins to connect them. To “close” a jumper, you connect the pins
with the clip. To “open” a jumper, you remove the clip. Sometimes a jumper will
have three pins, labeled 1, 2 and 3. In this case you would connect either pins 1
and 2, or 2 and 3.
SATA2 SATA1
CN15
FAN2
JP10
CN3
CN6
CN18
JP1
JP3
Battery
BIOS
CN10
JP5
JP6
JP9
J4
J2
J9 J8 J7 J6
JP4
SW2
CN25
CN9
J1
FAN1
JP2 Mini PCIe 3 Mini PCIe 2
Mini PCIe 1
SODIMM 2 SODIMM 1
M2_CN2
M2_CN1