46
GETTING TO KNOW YOUR ARS-2000
©Vecow ARS-2000 User Manual
2.6 Main Board Jumper & Deep Switch Settings
2.6.1 Top View of ARS-2000 with Jumper and Deep Switch
The figure below is the top view of ARS-2000 board, and it shows the location of
the jumpers and the switches.
You may configure your card to match the needs of your application by setting
jumpers. A jumper is a metal bridge used to close an electric circuit. It consists
of two metal pins and a small metal clip (often protected by a plastic cover) that
slides over the pins to connect them. To “close” a jumper, please connect the
pins with the clip. To “open” a jumper, please remove the clip. Sometimes a
jumper will have three pins, labeled 1, 2, and 3. In this case you would connect
either pins 1 and 2, or 2 and 3.
1
USB2_1 USB2_2
CN13
J9
J10
JP4
JP8
JP9 JP6
JP7
JP1
JP5
SW2
JP11
CN33
JP2
JP3
JP80
J11
J12
JCOM1
JCOM4
JCOM2
JCOM3
CN14
J3
U4
J4
J2
CN5
BZ1
FAN1
SODIMM2
SODIMM1
BAT
Summary of Contents for ARS-2000
Page 2: ...ii Version Date Page Description Remark 1 0 12 08 2017 All Official Release Record of Revision...
Page 62: ...55 HARDWARE INSTALLATION Step 3 Remove three PH M3x6L screws Step 4 Finish...
Page 70: ...63 HARDWARE INSTALLATION Step 3 Install PCIe PCI card to the socket Step 4 Fasten the M3 screw...
