AW 12s-62s, 12a-62a
17
Photo 29
Photo 30
Photo 31
7. Use a hammer and a screwdriver to remove the required number of cable blanks (see photo 29).
Break of the blanks with pliers, as in photo 30.
LED
A red LED above the terminal indicates the operating state and fault condition as follows:
Normal operation – master
Steady light
Normal operation – slave
Slowly flashing
Sensor fault - NTC input, terminal 1-2
Fast periodic flashing
Internal fault PCB – self monitoring
Two quick periodic flashes.
Cleaning
In order to perform at its peak, the fan heater must be cleaned regularly.
Dust on the water coil’s aluminium fins reduces airflow and its heat exchanging performance.
The coil must therefore be kept clean, which can be done in one of the following ways:
1. Blowing with compressed air.
2. Steam cleaning.
3. Spraying or rinsing with water. If the fins are greasy, add a suitable detergent.
For options 2 and 3, the fan motor must be protected against the ingress of water. When cleaning, the fan heater
must be disconnected from the power supply, and the air deflector grille and cleaning cover removed.
Also clean the fan protective grille and the fan blades with a soft brush.
The interval between each cleaning depends on the environment the fan heater is used in.
Summary of Contents for AW 12a
