11 Appendix
37 / 41
2 : Deactivated. Test mode: Data output
controlled by L=<p8>(*).
G=<p8> : Operation mode of the LUT. Changing this parameter may void
ex factory calibration.
0 : Deactivated. Image data is passed through
transparently.
1 : Activated.
2 : Deactivated. Test mode: LUT data is output
sequentially.
H=<p8> : Operation mode of the integrator / image store. This module
shares its memory with the background correction (U=<p8>).
This means that a new captured image with the command H=<p8>
overwrites the current image of the background correction.
The difference between H=<p8> and U=<p8> is the position
in the image processing chain: H integrates and outputs
data always at the beginning of the chain, which is
uncorrected camera raw data. U operates behind the two point
correction and thus integrates the data output of the two
point correction (see E=<p8>).
<d*cc_bbba>
| \| \_||
| | |+--a : Output mode.
| | | 0 -> Pass image data through unchanged.
| | | 1 -> Actual image memory content is output.
| | +---b : Control of integration process. Assigning a
| | new (not equal) value to this bit field
| | starts the corresponding action. Please
| | ensure that at least N+2 frames are output
| | from the camera head and let this amount of
| | time pass until a new value is assigned.
| | 000 -> No integration operation.
| | 001 -> Store the next image.
| | 100 -> Integrate 8 images and divide by 8.
| | 101 -> Integrate 16 images and divide by 16.
| | 110 -> Integrate 32 images and divide by 32.
| | 111 -> Integrate 64 images and divide by 64.
| | (Other values undefined.)
| +-------c : Control of the data copy process (usually
| done after a new image has been integrated).
| Let pass through at least one complete frame
| (to be sure: wait two frames) from the camera
| to completely copy the data. Set this field
| back to 00 after copying. Notice that the
| set values J and K are not affected.
| 00 -> No action.
| 01 -> Copy to Target A. The image store
| content of the integrator is subject
| to be copied into the correction
| data store as cold (low) reference
| image of the two point correction.
| 10 -> Copy to Target B. The image store
| content of the integrator is subject
| to be copied into the correction
| data store as warm (high) reference
| image of the two point correction.
+----------d : State of the integration process (read only).
0 -> Integration has finished.
1 -> Integration is still in progress.
I=<p8> : Set the mechanical shutter state manually (IRC-320/600 only).
0 : Shutter open.
1 : Shutter closed.
J=<p16> : Define the set value for the cold (low) reference image of
the two point correction. It is a 16 bits value of which
the 12 (or 14) most significant bits currently are used. For
each correction data set S=<p8> an own set value is stored.
All set values are loaded together from the flash file
N=<p8>. Changing this parameter may void ex factory
calibration.
K=<p16> : Define the set value for the warm (high) reference image of
the two point correction. It is a 16 bits value of which
the 12 (or 14) most significant bits currently are used. For
VDS Vosskühler GmbH
IRC-320
