13
04/11
INSTALLATION INSTRUCTIONS: Viewline 52 mm
Freshwater gauge (capacitive)
TU00-0752-9207102
1-5
4
Technische Änderungen vorbehalten - Technical details subject to change
TU00-0752-9207102
GB
12
Use the following connector to connect the instrument: Connector set,
8-pin - A2C59510850
The connector set is designed for a cable cross-section of 0.25 - 0.5 mm
2
.
For other cross-sections, please use contacts made by Tyco.
Single contacts:
Tyco No. 1355718-1 for 0.14 – 0.22 mm
2
Tyco No. 963729-1 for 0.5 – 0.75 mm
2
Strip:
Tyco No. 1355717-1 for 0.14 – 0.22 mm
2
Tyco No. 963715-1 for 0.5 – 0.75 mm
2
Create a crimp connection using the contacts and the corresponding
cables. Follow the instructions of the hand pliers manufacturer.
Use the following for this:
Hand pliers
Tyco No. 539635-1
And the tool
Tyco No. 539682-2 for these hand pliers
Pay special attention to whether the crimp barrel clutches all individual
wires in the cable, otherwise you risk a short circuit!
Connector set, 8-pin -
A2C59510850
Electrical connection:
•
Note cable cross-sectional area!
•
Reducing the cable cross-sectional area leads to higher current density,
which can cause the cable cross-sectional area in question to heat up!
•
When installing electrical cables, use the provided cable ducts and
harnesses; however, do not run cables parallel to ignition cables or to
cables that lead to large electricity consumers.
•
Fasten cables with cable ties or adhesive tape. Do not run cables over
moving parts. Do not attach cables to the steering column!
•
Ensure that cables are not subject to tensile, compressive or shearing
forces.
•
If cables are run through drill holes, protect them using rubber sleeves
or the like.
•
Use only one cable stripper to strip the cable. Adjust the stripper so
that stranded wires are not damaged or separated.
•
Use only a soft soldering process or commercially available crimp
connector to solder new cable connections!
•
Make crimp connections with cable crimping pliers only. Follow the
safety instructions of the tool manufacturer.
•
Insulate exposed stranded wires to prevent short circuits.
•
Caution: Risk of short circuit if junctions are faulty or cables are
damaged.
•
Short circuits in the vehicle network can cause fires, battery explo-
sions and damages to other electronic systems. Consequently,
all power supply cable connections must be provided with weldable
connectors and sufficiently insulated.
•
Ensure ground connections are sound.
•
Faulty connections can cause short circuits. Only connect cables
according to the electrical wiring diagram.
•
If operating the instrument on power supply units, note that the
power supply unit must be stabilized and it must comply with the
following standard: DIN EN 61000, Parts 6-1 to 6-4.
Warning contact
minus,connected
15 - terminal 15 - connected (ignition) plus
58 - terminal 58 - lighting
31 - terminal 31 - ground
Designations in the wiring diagram:
F1 - fuse 5A quick-response
C1 - 8-pin “Hirschmann MQS” connector
You must comply with the wiring diagram.
VDO Sensor
N02-240-402,
N02-240-404,
N02-240-406
