33
Installing the wind sensor
First, remove the base plate of the wind sensor. Proceed as follows:
Loosen the spring clip by pushing it down and inward (1), (2), then
remove the wind sensor (3).
When mounting the base plate, the sensor mounting direction should be
pointing ahead (0°) if possible. If this is not possible, other mounting
directions can be used (90°, 180°, 270°).
In this case, the vane must be dismantled by loosening the screw. Mount
the vane so that the direction is pointing ahead, while the white point
indicates the direction of the sensor arm.
INSTALLATION
Base plate
Vane
direction
pointing
ahead
White point
sensor arm
direction
Example:
Starboard sensor orientation
olwind_e.qxd 21.06.99 13:35 Seite 33
