ON
DIP
ASSEMBLY INSTRUCTIONS
Technical details subject to change
TU00-0761-5507150
10/18
Warning point adjuster 2910002025200
TU00-0761-5507150
1–3
2
EN
1
2
3
5
Before starting work, switch the ignition off and
remove the ignition key. Remove the main power
switch if necessary.
Disconnect the battery’s negative pole. Secure the
battery against being switched on again unintentionally.
•
Before starting work, disconnect the negative battery pole since there is a risk of short circuit otherwise.
If the vehicle has additional batteries, the negative poles of these batteries may also have to be
disconnected. Short circuits can cause cable fires, battery explosions and damage to other electronic
systems. Please note that all values entered in volatile electronic memories will be lost when the
batteries are disconnected and will have to be reprogrammed.
4
Adjusting the warning point:
For warning point adjustment set switch 3 to OFF and
switch 4 to ON.
Designations within the connection diagram:
C1 – Warning point adjuster
OUT1 – Switching capacity = 300 mA, not short cir-
cuit-proof
15 – Terminal 15 – Permanent positive 10 V–32 V
31 – Terminal 31 – Ground
Always adhere to the connection diagram.
Sensor - pressure, temperature and level sensors
from the standard VDO range
1 2 3 4
Reconnect the battery after you have checked the
connection.
•
Please note that all values entered in volatile electronic
memories will be lost when the batteries are disconnected
and will have to be reprogrammed.
Working procedure for installation of VDO SingleViu devices
1 2 3 4
ON
DIP
Signal
input
sensor
Terminal 31 (-)
Pin
6.3*0.8 mm
Terminal 15 (+)
Pin
6.3*0.8 mm
Potentiometer
Microswitch
S (signal)
Pin
6.3*0.8 mm
e.g. connection indicator
Terminal 31 (-) = (black)
Terminal 15 (+)/(red)
S (signal)/(yellow)
Out 1 (-)/(yellow)
Out 1 (+)/(red)
e.g. warning
