Please bear in mind that the fragrance level depends on a number of factors, such as the
following:
- Habituation may cause fragrances to be perceived less or not at all, but this is normal.
- When you lie on your belly, the fragrance is less noticeable than when you lie on your back.
- Airflows in the room where you use the appliance may also affect the fragrance level.
- Your personal condition may also influence the degree to which you perceive the
fragrance.
Storage
1
Let the appliance cool down for 15 minutes before you put it in transport position and
store it.
2
Store the protective goggles in the storage compartment between the two
lamps. (Fig. 17)
3
Make sure the cord does not get stuck between parts of the appliance when you put the
appliance in transport position.
4
Turn the appliance away from the bed or sofa and make sure there is enough space
around the appliance to collapse it.
5
Press the two release buttons in the recesses of the control panel and slide the control
panel down the stand as far as it goes. (Fig. 18)
6
Turn the lamp unit in the direction of the arrow. (Fig. 19)
You hear a click when the lamp unit locks in vertical position.
7
Pull the stand slightly backwards and then press the dual push button. Lower the stand
slowly until the lamp unit rests on the floor between the legs. (Fig. 20)
8
Wind the cord and fasten it with the Velcro cord wrap strip. (Fig. 21)
You can store the appliance in a wardrobe or under a bed.
Replacement
Tanning lamps
Always have the tanning lamps and starters replaced by a service centre authorised by VDL
Hapro. Only they have the knowledge and skills required for this job and the original spare
parts for appliance.
The light that the tanning lamps emit becomes less bright in time (i.e. after a few years in case
of normal use). When this happens, you notice a decrease in the tanning capacity of the
appliance.
- After 750 operating hours, the tanning capacity of the lamps has decreased so much that
replacement of the tanning lamps is advisable.
- The appliance has a counter that records the operating hours of the tanning lamps. After
750 operating hours, an
appears on the display to indicate that replacement of the
tanning lamps is advisable.
Note: Of course, you can choose to postpone replacement for a while by setting a longer
tanning time.
Viewing the operating hours of the tanning lamps
1
Set the time to 00 and press the repeat button ( ) to make the operating hours
appear on the display. The maximum number of hours that can be displayed is 999. The
number of hours is displayed for ten seconds.
ENGLISH
7
Summary of Contents for Hapro Innergize HP8580
