VDL Hapro Innergize HP8580, Manual

Page: 2 / 56

4
- In case of eye contact with the scent granules, flush the eyes immediately with plenty of
water.
General
- The appliance is fitted with an automatic protection against overheating. If the appliance is
insufficiently cooled (e.g. because the vents are covered), the appliance switches off
automatically. Once you have removed the cause of overheating and the appliance has
cooled down, it switches on automatically again.
Relaxation and your health
Warmth has a relaxing effect. Think of what a hot bath or lazing in the sunshine does to you.
You can enjoy the same relaxing effect by selecting the relax function or .
Bear in mind the following when you have a relax session:
- Avoid getting too hot. Increase the distance between yourself and the lamps, if necessary.
- If your head gets too hot, cover it or move your body so that less heat is emitted towards
your head.
- Close your eyes during a relax session.
- Do not let the relax session last too long (see section ‘Relax sessions: how often and how
long?’).
Relax sessions: how often and how long?
If you want to pamper your muscles or joints or want to enjoy the relaxing warmth of the
full-body solarium without getting a tan, only switch on the infrared lamps to get a deep
relaxation. If you want to continue enjoying the full-body solarium’s warmth after your tanning
session, switch on the infrared lamps only for a relax session.
You can take infrared relax sessions several times a day (e.g. 30 minutes in the morning and in
the evening).
Preparing for use
Note: You can easily move and store the appliance in transport position (Fig. 2).
1 Put the appliance on the floor as shown in the figure (Fig. 3).
Make sure there is sufficient room on either side of the appliance to allow the legs to move
outwards.
2 Press the dual push button in the handgrip (1) and pull the stand slightly up (2). Then
release the push button (Fig. 4).
On a smooth floor, the legs of the appliance automatically move outwards. If the floor is not
smooth, e.g. a carpeted floor, you may have to put your foot on one of the legs to allow the
other leg to move outwards.
3 Pull up the stand by the handgrip as far as it goes. (Fig. 5)
The stand locks into position with a click.
4 Turn the lamp unit in the direction indicated in the figure. (Fig. 6)
This requires some force at first. Push the lamp unit in the direction indicated until it locks into
position with a click.
Note: You can only switch on the appliance for a tanning or relax session if the lamp unit is in
the correct position.
5 Push the legs of the appliance under the bed or sofa you intend to lie down on. The
lamps for functions and are on the marked side of the appliance. (Fig. 7)
ENGLISH