VCS Videojet EE, Manual

Page: 59 / 78

61
VideoJet
Care and Service
7
Checking the network
The connection between two IP addresses can be checked using
the command
ping
. You can thus check whether the
VideoJet
in the network is active.
)
Open the DOS input window
)
Enter the command
ping
followed by the IP address of the
VideoJet
.
When the
VideoJet
is found, you receive in response:
Reply
from ...
, followed by the number of bytes transmitted and the
transmission time in ms. Otherwise the
VideoJet
cannot be
addressed via the network. This can have the following causes:
z
The
VideoJet
is not correctly connected to the network. In this
case, check the connecting leads.
z
The VideoJet is not correctly integrated into the network.
Check the IP address, the subnet mask and the gateway IP.
Maintenance
Ensure that only qualified, specialist personnel (electrical techni-
cians) are permitted to carry out maintenance or repair work or con-
tact the VCS Service centre.
Attention!
Never open the housing of the VideoJet or power supply unit. The
devices contain no parts which you can repair or replace.