VCS Videojet EE, Manual

Page: 57 / 78

Operation
59
VideoJet
Hardware connection
between
VideoJet
devices
You can link a
VideoJet
transmitter with connected video source
and a
VideoJet
receiver with connected monitor quite simply via
an Ethernet network. You can thus cover long distance without
extensive installation or wiring work.
Installation The
VideoJet
devices are set in such a way that they set up a
connection with one another automatically. For this, they simply
have to be installed in a closed network. Proceed as follows to
install the
VideoJet
:
)
Connect the devices to the closed network using an Ethernet cable.
)
Make the connection to the mains power supply.
Connection
set-up You have the possibility of setting up the connection either using a
terminal program or, with appropriate configuration, via the alarm
input. After a short time the live picture from the video source will be
displayed on the interfaced monitor.
)
Start the terminal program (see page 24) and enter the command
c
to set up the connection, or
)
Activate the alarm input to set up a connection.
Note
Ensure that the devices are configured in accordance with the
requirements of the network in which they are to be installed and
that the IP address of the other IPCom is set as the alarm IP
address.
Note
The connection set-up using the alarm input is only possible if the
option
Connect on alarm is activated on the configuration page
Alarm (see page 43).