10
VCON HD100 Getting Started Guide
Setting Up the HD100 Network Configuration
6. Restart the HD100. Startup information prints inside the HyperTerminal.
7. Press any key to stop the running of the HD100.
8. After the prompt, “
[VxWorks Boot]
:
”, type
C
and press <Enter>.
9. A series of HD100 parameters will appear with their current values. To
change a parameter, type the change in the line after the current value and
then press <Enter>. To use the current value, press <Enter> without
changing anything.
Set the parameters as follows:
After passing the “other” entry, the HD100 will reprogram the Flash
memory with this new set of parameters. This process may take up to 2
minutes. The HD100 is ready when the following prompt appears in the
HyperTerminal window:
[VxWorks Boot]
boot device : cf=0,00
processor number : 0
host name : vxhost
file name : cf0:ver\bin\vxworks
inet on ethernet (e) : <THIS COMPUTER’S IP ADDRESS>
inet on backplane (b):
host inet (h) : .
gateway inet (g) : <YOUR ORGANIZATION’S GATEWAY’S IP
ADDRESS>
user (u) : tetra_vc
ftp password (pw) (blank = use rsh): tetra_vc
flags (f) : 0x0
target name (tn) : tetra_vc
startup script (s) :
other (o) : rtl
CAUTION
DO NOT turn off the HD100’s power during the Flash
reprogramming! Turning off the power at this stage will
prevent the HD100 from initializing, therefore requiring
service.
