Step 7.
Place VersaClimber back into place and align the 3 holes.
Secure with the three 5/16” lag bolts and washers provided.
Firmly tighten down lag bolts. Next go to step 13.
Step 5.
With wall bracket attached, stand the VersaClimber up and
rest the bracket against the piece of 2x6 board that has been
securely mounted to the wall. Place the holes of the bracket
on the center line, then mark the bracket holes.
Center line.
Find the center line 75 inches
up from the floor.
The front base holes of VersaClimber should be
approx 38 inches in front of wall. Distance can vary
depending on wall, baseboards and or where the
bracket is positioned.
Step 6.
Mark the bracket holes on the center line. Remove the
VersaClimber and carefully place to the side. Drill 3 pilot
holes through the 2x6 wood support using 3/16” drill.
NOTE:
The two that go into the ground, may or
may not be needed. Our hardware may
not accommodate your wall, please
consult with a contractor.
Center line.
(190.5 cm)
75 inches
38 inches from wall
(96.5 cm)
NOTE:
38” from wall can vary depending
on wall, baseboards and / or
where the bracket is positioned.
Page 3
