BAG MARKED
STEP9-11
Adjustable Servo Mount Assembly
08
© VBC Racing FLASH04
Flash04 Adjustable Servo Plate A-03-VBC-1061 x 1
9
With both markings 'Y' facing outside.
The inner width is 20-21mm
Flash04 Servo Clamp Plate Right A-03-VBC-1059 x 1
Flash04 Servo Clamp Plate Left A-03-VBC-1060 x 1
Ball Connector B-02-VBC-0045 x 1
Servo Support Mount A-03-VBC-1011 x 2
Servo Horn 'A' A-03-VBC-1041 x 1
Servo Horn 'F' A-03-VBC-1042 x 1
M3x8 Roundhead Screw C-02-SC-R0308 x 2
M2.6x6 Flathead Screw C-02-SC-R2606 x 8
The Servo Clamp Plate width is adjustable by rotating the Servo Support Mount. Please adjust the width based on your mounting servo width.
Please make sure the marking of the same letter are both facing outside.
With both markings 'X' facing outside.
The inner width is 19mm
With both markings 'X' facing outside.
Insert 2mm washer not included between
the Servo Clamp Plate & Servo Support Mount,
the inner width is will be 15mm.
2mm washer (not included)
2mm
2mm
3mm
3mm
3mm
3mm
2mm washer (not included)
Horizontal Servo Layout for Dual Crank Steering System
M3x8 Roundhead
M3x8 Roundhead
Servo Horn (Please use Servo Horn 'A' or 'F' depending
on your servo)
Ball Connector
M2.6x6
M2.6x6
M2.6x6
M2.6x6
Double sided tape (not included)
Double sided tape (not included)
Servo Clamp Plate Left
Servo Clamp Plate Right
Servo Support Mount
Servo Support Mount
Flash04 Adjustable Servo Plate
M2.6x6
M2.6x6
M2.6x6
M2.6x6
Option2: Vertical Servo Layout for direct linkage
