Vaya V9, User Manual, Page: 11 / 16

PO-1684
11
CHARGING YOUR SCOOTER
Step 1: Ensure that the charging port is clean and dry.
Step 2: Plug the charger into a power outlet, then connect the cable with the power supply (100V ~ 240V; 50,60 Hz),
make sure the light on the charger is lit GREEN.
Step 3: Connect the charging cable to the charging port of the scooter. The indicator light on the charger should turn
RED, indicating that your scooter is now being charged. When the indicator light on the charger turns from RED to
GREEN, your scooter is fully charged. The charger will automatically stop charging when the light turns GREEN.
Step 4: Disconnect the charger from the scooter and the power outlet.
Note: If the GREEN light on the charger does not turn RED when you connect the charger to your scooter, check that all
the connections are properly made or that the scooter is not already fully charged.
WARNING: Remember to insert the charger rubber cover after every charge to protect it from water and dirt.
INSPECTION, MAINTENANCE, CLEANING AND STORAGE
Your scooter requires routine inspection and maintenance. This chapter describes maintenance steps and important
operating tips. Before you perform the following operations, ensure the charging cable is disconnected.
ATTENTION: Failure to follow the maintenance, cleaning and storage instructions can result in damage and corrosion
that can void the warranty claim.
INSPECTING YOUR SCOOTER
Each time before you ride the scooter:
• Check that the front wheel is properly aligned and connected to the handlebars. Position the front wheel between your
feet and gently move the handlebar from side to side to check that the wheel follows the handlebars. If you find any
problems, contact after sales support.
• Check that the E-scooter is correctly unfolded before riding.
• Check if the brake pads are worn out. If the brake pad is worn out (approximately less than 1 mm left) then they need to
be replaced immediately.
The E-scooter is subject to a lot of vibrations. Routinely check the body of the scooter and tyres for damage or
excessive wear. Check all bolts and screws and tighten them if needed. Double check screws around the folding
mechanism and the wheels.