Taking care of your machine
Taking care of your machine
Cleaning the filter and separator
Reassemble filter and separator
Emptying and cleaning the dirt container
Press the handheld
release clip. Pull to
separate the handheld
from the reach wand.
The reach wand when
attached to the Powered
Head/accessory is not
free standing. Place safely
and securely to one side.
Hold the handheld over a bin, press the dirt release
button to allow dirt/debris to fall out.
Remove the filter
from the lid.
Tap the filter, foam and
separator over a bin
to remove any dirt and
debris. Do not wash
the separator.
Wash the foam and
filter under running
water (max 40°C).
CAUTION:
Always empty the dirt container before cleaning the separator and filter. Remove the reach wand/
accessories from the handheld. Incorrect fitting of the separator and filter will reduce suction. Always switch off
the vacuum cleaner before carrying out any maintenance or troubleshooting. Do not use your vacuum cleaner
without the filters in place.
WARNING:
Don’t over fill the dirt container to avoid blocking the air flow through the vacuum cleaner.
To access the filter and separator twist the cap anti-clockwise and pull out.
To put the cap back on, push the cap into the unlock position ensuring it is fitted
correctly and twist clockwise to lock.
Leave for 24hrs or until
fully dry before replacing.
24hr
24hr
TIP
For best cleaning results, filters require cleaning every 3 months or as needed.
1 - SEPARATOR
2 - FOAM
3 - FILTER
4 - LID
Step 1: place foam
(2)
into separator
(1).
Step 2: place filter
(3)
into lid
(4)
with the pull
tab facing up.
Step 3: attach back
onto machine