Let’s talk technical
Replacing the belt
Lie the vacuum cleaner on its
back exposing the brushbar.
Use a cross head screwdriver
to undo the 5 screws.
Lift to remove the
brushbar cover.
Lift to remove the
brushbar. Remove and
dispose of the old belt.
Place the belt on the
rounded area of the
brushbar without bristles.
Line up the right side of the
brushbar with the base and push
into place. Lift and push the left
side of brushbar until it clicks
into place.
Clean any debris from
the spindle. Place the
new belt on the spindle.
Line up the brushbar cover
and push until it clicks
into place. Replace the 5
screws and tighten.
If the brushbar does not
rotate easily then the belt
may not have been fitted
correctly. Make sure the
belt is not twisted.
CAUTION
