WARNING:
Always turn OFF the steam mop when fi tting the cleaning pads.
WARNING:
When using on carpets, always make sure the microfi bre cleaning pad is used and covers the fl oor
head entirely before using the carpet glider. Only use the carpet glider when refreshing carpets.
IMPORTANT:
Never use the steam mop without a cleaning pad attached to the fl oor head. Never leave the
steam mop in one spot for extended period of time or with a damp or wet pad attached as this may damage
the fl oors surface.
Using your machine
Refreshing carpets
Place the microfibre pad
on the floor white side
facing up. Place steam
mop onto pad making
sure the entire pad
covers the floor head.
Place your foot onto the
floor head and pull handle
backwards to recline.
Plug into mains and slide
switch to ‘ON’ position.
The blue light will
illuminate to show power
on. The green light will
illuminate to show the
steam mop is ready to use .
Move the steam mop slowly
backwards and forwards
across the carpet paying
particular attention to high
traffic areas.
With microfibre pad
attached, hook steam mop
into the front of the carpet
glider and push to clip
into place. Carpet glider
should only be used when
refreshing carpets.
To produce steam,
squeeze the trigger.
To prevent over wetting
floors avoid holding the
trigger continuously.
To refresh carpets select
‘OFF’ setting on the
detergent dial.
To release the carpet
glider, place your foot on
clip and push down. Lift
steam mop to remove.
Taking care of your machine
