Vax SlimVac VX50, Let'S Get Started

Page: 9 / 13

Taking care of your machine Let’s talk technical
Cleaning the filter and separator
Refitting the separator, filter and dirt container
Tap the mesh filter and separator
over a bin to remove any dirt/
debris. Using a dry cloth wipe
away any remaining dirt/debris.
Line up the arrows
around the side of the
separator with the arrows
on the handheld. Twist
the separator clockwise
locking it into place.
Refit the mesh filter
with the rim of the
filter at the top. Twist
the filter clockwise
and lock into place.
Tilt the dirt container
slightly forward and line
up onto the handheld.
When the dirt
container is seated
on the handheld push
the dirt container
backwards to lock
into place.
Removing blockages from the Powered Head
The brushbar should be removed from the Powered
Head before attempting to remove any blockages.
Using scissors, carefully remove any threads or hair
from around the brushbar and clear any dirt
or debris from Powered Head.
IMPORTANT: If the brushbar has been obstructed, the Motor Protection Sensor may have been activated and the
brushbar will seize. Remove the Powered Head from the machine and clear any obstruction. Refit the Powered
Head, switch on the vacuum cleaner by pressing the trigger and press the brushbar on/off button.
CAUTION:
Incorrect fitting of the separator and filter will reduce suction.
Removing and replacing the brushbar
Slide to release the
brushbar. The cover
can not be removed.
Lift to remove the left side
of the brushbar first.
Clear any threads or hair
from both ends of the
brushbar and any dirt/
debris inside the housing
of the Powered Head.
When re-fitting the
brushbar fit the right side
into the housing first.
Then line up and slot into
place the left side.
Removing blockages from reach wand
To test for a blockage in the reach wand, drop a small
ball of paper into the wand. The paper will drop through
if the wand is clear. Use a broom handle or similar blunt
object to remove any blockage.