Using your machine
CAUTION:
Always allow the steamer to fully cool down before removing the microfibre pad.
The blue light will illuminate
to show power on and
steamer is heating.
Refreshing carpets
IMPORTANT:
When using on carpets, always make sure the microfibre cleaning pad covers the floor head entirely
before using the carpet glider. Only use the carpet glider when refreshing carpets
Place the microfibre pad on
the floor white side facing
up. Place steamer onto pad
making sure the entire pad
covers the floor head.
With microfibre pad
attached, place steamer
into the carpet glider.
The carpet glider should
only be used when
refreshing carpets.
The green light will
illuminate to show the
steamer is ready to use.
The green light will go
off when the steamer is
re-heating.
Plug into mains and press
the power button to
switch on.
Place your foot onto the
floor head and pull handle
backwards to recline.
To produce steam squeeze
the trigger in short bursts.
Don’t hold the trigger
continuously to prevent
over wetting carpets.
Move the steamer slowly
backwards and forwards
across the carpet paying
particular attention to high
traffic areas. Squeeze/
release trigger as required.
Lift steamer off
carpet glider.
Hold corner of pad down
with your foot and lift
steamer to remove.
