Press the water tank
release button and pull tank
to remove.
Pull the tab on water tank
cap to open.
Fill water tank with
max 400ml of water.
Replace cap and push
firmly to close.
Place your foot onto the
floor head and pull handle
backwards to recline.
Place the microfibre pad on
the floor white side facing
up. Place Steamer onto pad
making sure the entire pad
covers the floor head.
To produce steam squeeze
the trigger in short bursts.
Don’t hold the trigger
continuously to prevent
over wetting floors.
Plug into mains and press
the power button to
switch on.
Using your machine
Filling water tank
Using your steam mop
To replace water tank, line
up base of water tank into
ridge of steamer. Push to
click into place.
IMPORTANT:
Never use the steamer without a cleaning pad attached to the floor head. Never leave the steamer in one
spot for extended period of time or with a damp or wet pad attached as this may damage the floor surface.
CAUTION:
Always allow the steamer to fully cool down before removing the microfibre pad.
Move the steamer slowly
backwards and forwards
across the floor paying
particular attention to high
traffic areas. Squeeze/
release trigger as required.
The blue light will illuminate
to show power on and
steamer is heating.
Hold corner of pad down
with your foot and lift
steamer to remove.
The green light will illuminate
to show the steamer is ready
to use. The green light will
go off when the steamer
is re-heating.
Using your machine
