12
Cleaning and maintenance
Using a coin, push and
turn the brushbar cover
anticlockwise to the
unlock symbol.
Pull the brushbar out from
the brush housing.
To remove any threads or
hair, slide the blade of a
pair of scissors into the
groove on the brushbar
and cut along the groove.
Clear any dirt/debris from
the end caps and inside the
brush housing.
Refit the brushbar into the
floorhead. Align the arrow
on the brushbar cover to the
unlock symbol, push firmly
until the cover sits flush and
turn to lock into place.
IMPORTANT: If the brushes have been obstructed, the motor protection sensor may activate.
The brushes will stop and the light on the floorhead will illuminate red. Switch off the machine, clear
any obstruction and wait 1 minute before reactivating.
Removing and cleaning the brushbar
NOTE: For best performance and to reduce hair and dirt build up, remove and clean the brushbar
every 1-2 months (depending on the level of use).
