Function Descriptions
1) Automatic Recording
When you start your car engine, the DVR is automatically turned on and the
record function is enabled. When your car engine shuts down, the DVR will
automatically save the recorded footage and power off. The recorded data
will be saved on the micro SD card. When the micro SD card is full, it will
overwrite the existing data.
Note:
You can set the loop record time through the menu. The time period can be
set to 1 minute, 3 minutes, and 5 minutes. The default time is 3 minutes.
2) Manual Recording
Press the REC Button to manually start or stop recording a video.
3) Snapshots
In standby mode, press the MIC Button to enter the snapshot mode. A
camera icon will appear in the upper left corner of the screen in place of the
video icon. Now, you can press the OK Button to take photos. Press the MIC
Button twice to switch back to recording mode.
4) Motion Detection
In standby mode, press the Menu Button to enter the menu page. Press the
MIC Button to move down the cursor to the Motion Detection option. Press
the OK Button to activate the motion detection function. If a moving object
Modes
Record Mode: The DVR automatically starts recording when the car is started.
Standby Mode: When the DVR is recording, press the REC Button to stop filming.
Snapshot Mode: In standby mode, press the MIC Button to enter snapshot
mode, then press the OK Button to take photos.
Playback Mode: In standby mode, press the MIC Button twice to play back
recorded footage.
05/06
is detected, the DVR will automatically start to record a video and stop if no
motion is detected for 60 seconds. To disable motion detection, go to the
menu page again and set the Motion Detection option to OFF.
5) G-Sensor
The DVR is designed with a built-in collision sensor (G-sensor). In case of a
vehicle collisions, the DVR will generate an emergency recording at the time
of the accident with a lock icon on the screen.
Note:
The G-sensor function supports sensitivity adjustment. By default, the DVR
is set to medium sensitivity. You can change the sensitivity settings as
needed in the menu.
6) Date and Time Setting
In standby mode, press the Menu Button twice to enter the system settings
page. Press the REC or MIC Button to move the cursor to the Date / Time
option. Press the OK Button to confirm and return to the menu page.
Note:
To obtain a correct time stamp from your footage, please set a correct date
and time before using the DVR.
7) Data Transfer
Connect the DVR to the USB port of a PC to view the recorded photos and
videos.
area.
5) Plug the USB terminal of the cable to the car charger.
6) Adjust the angle of the DVR, make sure the camera lens is level with the
ground.
7) Check whether the DVR is properly mounted, then start the engine to turn
on the DVR.
