Vauxhall Astra 2014, Infotainment Manual

Page: 10 / 53

Introduction 9
The steering wheel remote control
has other functions in conjunction
with the Mobile phone portal, see
chapter for Mobile phone portal.
Operation
Control elements
The Infotainment system is operated
optionally via:
■ the central control unit in the
instrument panel
3
6
■ controls on the steering wheel
3
6.
The operation of the Infotainment
system can vary with the information
display type. There are two different
information displays available: Triple-
Info-Display (TID) and Graphic-Info-
Display (GID). See "Information
displays" in the Owner's manual for
further information.
Switching the Infotainment
system on or off
Press the
e
knob.
The audio source last set is played.
Switching on and off with the ignition
key (automatic switch-on)
If the automatic switch-on is enabled,
the Infotainment system can also be
switched off and on again via the
ignition.
This link between the radio and
ignition is preset in the factory, but this
can be disabled.
■ If the automatic switch-on is
disabled, the Infotainment system
can only be switched on with the
e
button or by inserting a CD and
off with the
e
button.
■ If the Infotainment system is
switched off when the ignition is
switched off, regardless of the
current setting of the automatic
switch-on it, can only be switched
on via the
e
button and by inserting
a CD.
■ The automatic start is always
enabled after the Infotainment
system has been disconnected
from the operating voltage and re-
connected.
Enable/Disable Ignition Logic
TID only:
1. Press SETTINGS button to
display Audio.
2. Press
n
button to display
System.
3. Press OK button repeatedly until
Ign.Logic ON or OFF (depending
on the current setting) is
displayed.
4. Select the desired status with the
m n
buttons.
After a few seconds Audio is
displayed, followed by the relevant
audio source.
Or:
Press one of the function buttons
TUNER, MEDIA or BC to display the
relevant function.
GID only:
1. Press SETTINGS button to
display the Settings menu.
2. Press
n
button to select System.