Driving and operating
129
When the vehicle is started,
)
illuminates briefly.
The system is only operable at
vehicle speeds above 35 mph and if
lane markings are available.
Fault
The lane departure warning system
may not operate properly and
)
may
not appear if:
■ The lane markings on the road are
not detected.
■ The camera sensor is blocked by
dirt, snow or ice.
■ The windscreen is damaged.
■ The weather is limiting visibility.
This is normal operation; the vehicle
does not need servicing. Clean the
windscreen in front of the camera
sensor.
Lane markings may not be detected
on curves, motorway exit ramps or
hills.
If any other problem occurs or if a
problem persists, seek the assistance
of a workshop.
9
Warning
If the camera sensor is blocked by
dirt, snow, or ice, or if the
headlights are not cleaned or
properly aimed, or if the
windscreen is dirty or damaged, it
may not detect the lanes ahead.
The lane departure warning
system may not help avoid a crash
under these conditions. Keep the
headlights cleaned and properly
aimed and the windscreen clean.
The warnings may occasionally occur
due to tar marks, shadows, cracks in
the road, or other road imperfections.
This is normal system operation; the
vehicle does not need servicing.
Lane departure warning system
messages
Messages may appear in the Driver
Information Centre (DIC) providing
information about the lane departure
system.
Charging
This section explains the process of
charging the vehicle's high voltage
battery. Do not allow the vehicle to
remain in places with extremes of
temperature for long periods without
being driven or plugged in.
The vehicle must be plugged in when
the temperatures are below -25° C to
operate properly and to maximise
high voltage battery life.
However, we recommend plugging in
the vehicle when temperatures drop
below 0° C or raise above 32° C.
The charging system may run fans
and pumps resulting in noises coming
from the vehicle while it is turned off.
Additional clicking sounds may be
caused by the electrical devices used
while charging.
While the charge cord is plugged into
the vehicle, the vehicle cannot be
driven.
Charge mode selection
Press
8
until Charging is displayed.
