2. Screw the control box to an accessible point with 4 screws (8 to 10mm diameter) or fix it to the base.
Consider the travel path of the TV when positioning the control box and the other components.
The cables may not be bent or damaged
.
3. Mount the operating element with 2 screws to the point provided on the piece of furniture.
4. Connect the electrical connectors: refer to section 5.
5. Mount the retainer plate to the flat screen.
6. Drive the telescopic column upwards out of the piece of furniture.
7. Hang the screen with both hook flaps on the retainer plate to the
corner of the telescopic column, insert the mushroom-head screws
from above and screw from below with the washer and hexagon
nut (key width 13) in position 2 so that the connections can still
be slid.
6
2
8. Set the height of the screen so that a clearance of 10mm between
the top edge of the screen and the top edge of the telescopic drive
remains.
There must be a minimum clearance of 15mm between the bottom
edge of the screen and the motor housing of the telescopic drive
which results in a maximum screen height of 765mm.
Make sure that the screen is horizontal.
To set the height, tighten the two hexagon nuts (SW13) pos. 1.
Then set the depth of the screen and fix (tighten) with the hexagon
nuts (SW13) – pos. 2.
After assembly, check whether it is possible to drive the
mounted screen on the TV lift without it colliding with any
objects and check whether all cables have been laid correctly
(no cables are crushed, sheared or buckled etc).
m
ax
.
7
65
m
m
10
m
m
15
m
m
2
1
