A
64
31
15 32
B
64
Locking clip
5
Align sliding frame
With the aid of the two adjusting
screws (bottom) the frame can be
aligned vertically: front adjusting
screw anticlockwise - frame is
raised at the front and tilts to the
rear, rear screw anticlockwise -
frame is raised at the rear and
tilts to the front, by turning the
screws clockwise the frame
behaves in the opposite manner.
With the aid of these adjusting
screws the frame can also be
raised or lowered if necessary by
adjusting both screws by the
same amount.
6
Connect frame to front
Pull out the frame, screw the top
coupling arm together with the
flange sleeve and the M 6 x 12
screw to the threaded sleeve on
the top cover plate. Fit the bottom
coupling arm together with the
flange sleeve and a spacer to the
pin and secure with the washer
and locking clip.
Fastening material:
Screw M6 x 12
Flange sleeve 2 off
Washer
Locking clip
7
Fit plastic brackets
The bottom plastic bracket is to
be fitted such that the distance
between the bottom shelf and the
bottom fastening holes is the
same as dimension "A" as per
table A. The position of the top
plastic bracket is dependent on
the installation height. The
distance "B" is to be found in
table A.
If there are fouls with existing
front hinges, then the dimension
"A" will need to be adjusted as
appropriate - Caution: this
situation must also be taken into
account in point 8 "Fit front
frame"!
Now place the rails in the plastic
brackets and connect with
bearing pins
Fastening material for fitting
without spacer
(not included):
Pan head screws 4.0 x 16
or Euro screws 6.3 x 13
Sliding frame
Guide unit
Ball bearing guide
Top
Plastic
clip
Cover plate
Clamping
screw
Threaded
sleeve
Flange sleeve
M6 x 12
Top coupling arm
Flange sleeve
Bottom coupling arm
Washer
Adjusting screws
Bearing pin
Plastic bracket
Pan head screws
4.0 x 16
Rail
5 mm spacer
available as an
optional extra
Pin
Table A
Installation
Dimension Dimension
heights
"A"
"B"
DUSA 1
650 -
950
190
DUSA 2
950 - 1200
510
DUSA 3 1200 - 1450
718
DUSA 4 1450 - 1700
162
718
DUSA 5 1700 - 1950
1118
DUSA 6 1900 - 2150
1118
DUSA 7 2150 - 2350
1118
If may be necessary, depending on the
design of the hinges, to fit spacers to
increase the distance between the rail
and side of the cabinet. These are
available as an optional extra.
Sliding section
