16
|
Vauni Globe
© Copyright 2015 Vauni AB - All rights reserved
ENG
7 FAULT FINDING
The burner cannot be lit
Possible causes:
• No fuel is in the burner module.
• The fuel level is too low.
• The burner’s safety system makes it hard to start.
• The fuel being used is incorrect, or has been diluted by excess cleaning liquid or the like.
• The regulator lid is not fully open.
Measures:
• Add fuel.
• Start the burner according to the instruction in Section 4.1.
• Change the fuel. See Section 4.2.1 for recommendations.
• Open the regulator lid until it stops. If the burner opening is still not fully exposed, see
the assembly instructions for correct placement. If this does not help, contact the place of
purchase for the nearest service technician
The burner starts but goes out again
Possible causes:
• Low fuel level.
• The regulator lid is not fully open.
• The burner’s safety system makes it hard to start.
Measures:
• Repeat the starting procedure.
• Add fuel.
• Start the burner according to the instruction in Section 4.1 point 4.
• Open the regulator lid until it stops. If the burner opening is still not fully exposed, see
the assembly instructions for correct placement. If this does not help, contact the place of
purchase for the nearest service technician.
The flame is unstable, or unusually large, or it leans toward one side
Possible causes:
• The flame is exposed to a draught.
• The burner is leaning on its foot.
• The wrong type of fuel is being used.
• Soot or residue particles have fallen down into the combustion system during operation.
Measures:
• An unusual flame can result if the flame is exposed to strong draught. This applies especially
Summary of Contents for OF Wide
Page 2: ......
Page 20: ...20 Vauni Globe Copyright 2015 Vauni AB All rights reserved ENG...
Page 39: ......