Care Instructions -
Read Before Installation
- This box contains fragile and valuable goods that
have been carefully packed. Please take utmost care
in unpacking the parcel as damage can occur in this
process.
- Please be sure you have received the correct
number of boxes i.e. 1 of 2, 2 of 2 etc.
- Under no circumstances should the product be
lifted out by the neck or light fitting.
- If you have received any damaged goods or are
missing any part of your order, please contact our
sales office as soon as possible
Recycling
- Recyclable packaging used, please consult with
your local recycling centre for further information.
- Waste electrical products should not be disposed
of with conventional household waste. Please
recycle all parts when possible.
Cleaning Instructions
Brass
- all types: Use a soft dry lint free cloth
Bronze, Nickel, Silver & Chrome:
Use a dry cloth
only, no chemical cleaners
Glass:
We recommend using a strong alcohol such as
isopropyl alcohol. Note: some modern cleaning
solutions can contain chemicals that can leave a
greasy film on glass.
Gilt Wood:
Use a dry cloth only
Ceramic:
Use a damp cloth only
Wood:
Wax polish i.e. Antique wax
Alabaster:
Dust with a soft brush or a clean dry cloth.
Avoid water or water-based cleaners. Any marks that
cannot be removed by dusting must be cleaned by a
specialist.
Lacquered Furniture:
Furniture polish
Crystal:
Damp cloth
Card/Laminated Shades:
Use a Feather duster only
Silk Shades:
Gently tap to lift dust
Needlework:
Dry-clean
-Any decorative parts made from other materials
must be removed and cleaned separately to avoid
damage - e.g. alabaster.
After choosing a suitable location that meets all the requirements of the safety
information install the unit following the steps overleaf.
- Carefully unpack all parts and check for damage or missing parts before
commencing installation.
- Installation of this product must be carried out by a qualified electrical
contractor.
- Shut off power at the fuse box or circuit breaker box.
- If necessary, remove old fixture and all mounting hardware from the junction
box.
-Be sure to follow the steps in the order given.
- The supply wires must be rated for at least 90°C
-This product must be installed in accordance with all applicable installation
codes by a person familiar with the construction and operation of the product and the hazards involved.
- Ensure that the support for the luminaire is of sufficient structural strength and that any fixing screws do not interfere with
the connecting cables.
- The light must be mounted on a non-flammable surface as a fixed luminaire, and is not suitable for portable use.
- The unit can get very hot during use. Switch the product off and allow to cool before handling or changing bulbs.
- Ensure adequate ventilation space is allowed between the unit and any object above, in front or to either side of the unit.
Suggested minimum space is 19½” above and 19½” on all sides.
- To prevent tarnishing, it is advisable to wear gloves at all times when handling the product.
- mains connectors must be wire nut connectors, with wet locations rating, with capacity for 3 x 18AWG cables.
Safety Information - Read Before Installation
VAUGHAN
Installation Guide
www.vaughandesigns.com
Hawley Lantern
CL0353
Rev 1
