2
INSTRUCTIONS OF USE AND MAINTENANCE
GENERAL POINT
Refrigerating components
Refrigeration by a ventilated evaporator located in the top of
the cupboard.
Self evaporating tray
Evaporation by heating element, placed in a vat stainless,
placed with the compressor.
Controls
High precision control by thermostat with digital display ( to
refer to the note of the thermostat provided hereafter ).
Started and stop of the regulation by pressure on the key
of the keyboard of the thermostat.
Control devices placed on the panel of aeration of the
compressor group of the display.
Protection
By main power fuse holder.
INSTALLATION
Electric connection
Before plugging in the unit, control imperatively the
voltage rating : it should be the same voltage as
indicated on the unit.
The electric power line providing the refrigerated unit with
electricity should be protected by a differential circuit breaker
located on the main electric distribution panel.
HOW TO USE
To put into service
Powering up the unit two hours before usage.
Press the key
of the thermostat
When the thermostat is activated, the power unit starts
running a minute later (safety timeout) to supply power.
The thermostat is adjusted in the factory after testing.
When the desired temperature is obtained, the power unit
automatically turns off.
Press the key
of the thermostat to turn off the regulation
of the unit.
Adjusting the thermostat
Refer to the manual for details.
Automatic defrosting
This function is programmed in the thermostat/
Adjusted in the factory: the defrosting engages every hour
throughout one ten maximum minute.
To modify the adjustment, refer the manual of the
thermostat.
Cleaning
To be performed when the cupboard is shut down (the unit is
turned off).
Once a day, wash the top, the refrigerated well and the
external sides of the cupboard.
Use a sponge moistened with a soapy water or special
cleaning products to clean the stainless steel. Rinse off with
water. Dry preferably with lint-free cotton cloths.
Do not use floor cleaning products or acids, even diluted,
chlorinated or scouring products, which may cause corrosion to
stainless steel.
Do not use any abrasive products (steel wool, etc…).
Do not clean the refrigerated unit by spraying with water,
using a soap gun, or under high pressure jets.
MAINTENANCE
The installer should check all the electric connections during
the initial start up of the unit (and then once a year).
Clean the condenser every six months.
Grease the condenser blower shaft once a year.