Vatech pDRIVE CX profi, Operating And Mounting Instructions Manual

Page: 106 / 111

Operating & Mounting instructions – 8 074 143.03/03 – Appendix A3
No. Parameter name Factory default Setting Page
A054 DC braking: braking torque
0 % 26
A055 DC braking: braking time 0,0 s 26
A056 DC braking: edge/level selection 01 26
A057 DC braking: braking torque (start) 0 % 26
A058 DC braking: braking time (start)
0,0 s 26
A059 DC braking: carrier frequency 3,0 kHz 26
A061 Frequency upper limit 0,00 Hz 29
A261 2nd Frequency upper limit 0,00 Hz 54
A062 Frequency lower limit
0,00 Hz 29
A262 2nd Frequency lower limit 0,00 Hz 54
A063 1st Jump frequency 0,00 Hz 30
A064 1st Jump frequency width 0,50 Hz 30
A065 2nd Jump frequency
0,00 Hz 30
A066 2nd Jump frequency width 0,50 Hz 30
A067 3rd Jump frequency 0,00 Hz 30
A068 3rd Jump frequency width 0,50 Hz 30
A069 Acceleration stop frequency
0,00 Hz 35
A070 Acceleration stop time 0,0 s 35
A071 Selection of PID function: ON/OFF 00 32
A072 PID controller: Proportional gain (kp) 1,0 32
A073 PID controller: Integral gain(Tn)
1,0 32
A074 PID controller: Differential gain(Tv) 0,00 32
A075 PID controller: Scale conversion 1,00 33
A076 PID controller: Feedback destination 00 33
A081 Selection of AVR function
02 34
A082 Selection of voltage for AVR 400 V 34
A085 Operation mode selection 00 57
A086 Energy saving response 50,0 57
A092 2nd Acceleration ramp
15,00 s 34
A292 2nd Second acceleration ramp 15,00 s 55
A093 2nd deceleration ramp 15,00 s 34
A293 2nd Second deceleration ramp 15,00 s 55
A094 Select method of 2nd stage
00 34
A294 2nd Method of second stage selection 00 55
A095 Switch-over 1./2. acceleration ramp 0,00 Hz 35
A295 2nd Stage Acceleration change over point 0,00 Hz 55
A096 Switch-over 1./2. deceleration ramp
0,00 Hz 35
A296 2nd Stage Deceleration change over point 0,00 Hz 55
A097 Pattern of acceleration ramp 00 35
A098 Pattern of deceleration ramp 00 35