11)
The belt needs to be tightened and adjusted. To tighten and adjust the belt, use the Aligner Bolts. To raise the
Aligner, turn the Aligner Bolt clockwise with a 7/16” wrench. To lower it, turn it counter clockwise. Start with the
belt centered on the pulley.
12)
To track the belt and continue machine setup, follow
Startup Procedure
in
Operation
page 1. To track the belt,
follow instructions found on
Belt Tracking
page.
10)
The belt needs to be installed as shown in the diagram below. For dryers with an (optional) rear drive idler,
please see
Optional Drive Idler
page
.
Be sure the belt is routed over all braces on the conveyor and over the
Aligner. To connect your belt, align the Alligator Lace and install the pin.
Alligator lace
Aligner
Brace
10
10
Belt
Assembly
(5of5)
13) Install OPTIONAL conveyor end caps on 3 corners.
The corner of the dryer with the motor installed has a unique cover that is pre-installed.
End caps are installed with (4) #8 sht-metal screws each as shown below.
Motor Corner
(directly behind control box)
Install End Caps
on 3 corners
End Cap
#8 Sht Metal
Screw
9)
Install the crank handle onto the shaft on top of
the chamber. Align set screw to the flat on shaft
and tighten with 1/8” allen wrench. Raise heaters
to full up position.
Allen Wrench
Flat
Set Screw
Crank Handle
Pg. 8
