08
Note: Boost mode can be activated at any time, regardless of the current operating
mode (Auto, Comfort, Eco or Frost protection).
To activate Boost mode, press the
button, the temperature setpoint is raised to the
maximum for the amount of time requested. 30 minutes flash by default.
- First press = Boost.
During the 1
st
minute: The heating indicator
symbol comes on, the Boost light and the
duration countdown flash.
During the 1
st
minute, you can change the duration of the Boost from 0 to the maximum
permitted duration of the Boost as defined in the advanced settings (see BLOWER Detailed
Settings Manual on the website for more details) at 5-minute intervals by pressing
and
. This change will be saved and will be effective for the subsequent Boosts. The Boost
countdown begins after 1 minute and the time elapses, minute by minute.
The Boost may stop for 3 different reasons:
-
FILE
appears on the display:
BOOST
The blower stops. Ensure that nothing is placed in front of the ventilation grille so that the flow
of air is not obstructed. The filter may be clogged by dust; it must be cleaned.
Note:
if the filter is clogged or if the grille is covered unintentionally, a special sensor will turn
the device off. Normal operation of the device will resume the next time it is started if the filter
or the grille is not obstructed, but only after the blower has cooled down.
- If the ambient temperature reaches the maximum Boost temperature during
countdown:
The blower stops but Boost mode is still
active: the countdown is still displayed, the
Boost symbol on the display and the heating
indicator symbol flash. When the temperature
drops below the maximum authorised
temperature the blower will be reactivated
until the end of the countdown.
- Second press = cancel Boost.
The indicator lights of the previously active mode come on and the setpoint temperature is displayed.
NL
FR
DE
EN
IT
09
The blower can be used as additional instant heating if there is a significant difference between
the ambient temperature and the required setpoint temperature.
Super comfort is triggered if the difference between the ambient temperature and the setpoint
temperature is more than 2°C.
sCf
ead the Super comfort setpoint temperature
appear on the display alternately for 2 seconds.
Super comfort stops if:
- The difference is less than 0.5°C.
- The difference is still more than 2°C after
1 hour of Super comfort.
Note:
Super comfort is valid only in Comfort and
Auto - Comfort mode
.
When the flow of air is cut, the post-ventilation
function is switched on. This feature protects the
blower, ensuring more rapid cooling of the internal
components following a period of heating.
A countdown can be seen on the screen and the
buttons on the keypad remain inactive during this
time.
SUPER COMFORT
POST-VENTILATION
A selector indicates the level of energy consumption by aligning itself automatically in the
display opposite a colour: red, orange or green.
The gauge appears in the Auto, Comfort, Eco and Frost protection modes, regardless of the
temperature.
C - Red
High temperature
Setpoint > 22°C
If the setpoint temperature
is above 22°C
B - Orange
Average temperature
19°C < Setpoint ≤ 22°C
If the setpoint temperature
is above 19°C and below
or equal to 22°C
A - Green
Low temperature
Setpoint ≤ 19°C
If the setpoint temperature
is below or equal to 19°C
You can see the estimate of energy consumed by the device in kWh since the last reset of the
energy meter to zero.
ENERGY CONSUMPTION
Summary of Contents for KERMI Mabeo Aero MBA101200502XXK
Page 43: ...NOTES NOTES...
Page 44: ...9 0 D R 0 1 7 0 2 6 C D00020099 2019 07 6918289...
