Panel Mounting Procedure
1
. Cut and drill the panel (refer to panel mount drawing). Measurements are in inches.
Panel Mounting Cutout
2. If access to the side of the monitor is not available following installation, attach the power
and video cables to the side of the monitor at this time.
3. Install the monitor in the prepared cutout.
4. Install the lock nuts and washers, supplied with the monitor, behind the holes running along
the sides and top/bottom of the cutout in the panel. Extra lock nuts and washers are provided.
Note:
Use #10-32 nuts for mounting.
5. Tighten all mounting nuts evenly to a torque of 24 inch-pounds.
ATTENTION:
Mounting nuts must be tightened to a torque of 24 inch-pounds to provide
panel seal and avoid potential damage. Vartech Displays assumes no responsibility for water or
chemical damage to the monitor or other equipment within the enclosure due to
improper installation.
6. Attach the power and video cables to the side of the monitor if you
have not already done so. .
4.2
Panel Mount Procedure
13