POWX1310
EN
Copyright © 2021 VARO
P a g e
|
7
www.varo.com
Remove the flange nut from the spindle using the wrench.
Position the saw blade and the flange.
Place the flange nut from the spindle and tighten it with the wrench.
Take care that the flange nut will be placed with the correct aide on the spindle.
Release the spindle lock and check that the spindle is unlocked by rotating it.
Close the top of the base plate and fasten four screws.
Make sure that the top of the base plate is securely closed before operating
the machine.
8.2
Mounting dust bag
For dust extraction the dust bag can be used. Insert the dust bag into the vacuuming
connection. Empty the dusts bag regularly so that the vacuuming performance remains intact.
8.3
Attaching the plate protection
The plate protection needs to be attached to the angle stop prior to use. For easier assembly,
set the angle stop into the 90° position. Slide the plate protection onto the angle stop with the
plastic locating arms positioned over the top, and the plastic face being located underneath.
9 OPERATION
9.1
Switching on and off.
Never use the spindle lock until the machine is working.
To switch the machine on push the lock-off button and the on/off switch trigger at the
same time.
To switch the machine off, release the on/off switch trigger.
Never use the spindle lock to stop the motor.
9.2
Marking the workpieces.
Before starling with the biscuit jointer the work pieces must be marked as following:
Place the two work pieces which must be connected, on top of each other.
Fasten the work pieces and mark the center of the groove.
The space between two grooves should be 10-15cm. This is not applicable for smaller
workpieces- smaller work pieces don't have to be marked
9.3
Positioning of the machine
Based on the size of the work pieces the machine can be positioned in several ways.
9.4
Large workpieces:
Place the machine near the work piece
The middle of the base plate (this point is marked on the base plate) must face the center
of the groove in the work piece, {see marking the work piece).
9.5
Small workpieces.
Place the machine near the work piece
The side of the machine must be lacing the side of the work piece.
9.6
Sawing grooves
Move the motor base backward.
Place the machine near the work piece.
Position the machine (see positioning of the machine)
Hold the machine with both hands and switch the machine on.
Push the motor base carefully forward as far as possible.
