POWX1310
EN
Copyright © 2021 VARO
P a g e
|
6
www.varo.com
Always wear safety goggles and hearing protection. If desired or required also use another
protection for example an apron or helmet
Always disconnect the plug from the socket before carrying out any work on the machine,
only plug in when the machine is switched off
Keep mains lead clear from working range of the machine. Always lead the cable away
behind you.
The base plate must not be clamped down while the blade is extended. Lowering and
raising the blade must be a smooth operation,
7 ADJUSTMENTS
7.1
Adjusting the cutting depth
Move the motor base (14) as far as possible backwards.
Set the cutting depth by luring the cutting depth adjustment knob (6). The knob is marked
“0”, “2”, “4”, “5”, “7”, “12” and “19” according to the sizes of dowels.
Move the motor base forwards and check if the pin will fall in the notch of the adjustment
knob.
7.2
Adjusting the cutting angle
The cutting angle can be set by unlocking the clamping knob (7} and put the angle stop (4)
in the required angle.
7.3
Adjusting the height
The correct height can be set by unlocking the clamping knob (8) and turning the knob for
the height adjustment (9) to the desired height with aid of the scale (10)
The height must corresponds to half of the material thickness of the work piece, the
groove lot the biscuit dowel must always be in the middle of the working piece
7.4
Checking the cutting depth
Always check the cutting depth after mounting a saw blade.
Disconnect the plug from the socket.
Move the motor base (14} as far as possible backwards.
Set the cutting depth in the maximum position by turning the depth adjustment knob (6).
Move the motor base forwards till the pin will fall in the notch of the adjustment knob (6)
Turn the saw blade till one tooth of the saw blade is in the front position.
Measure the distance from the side of the base plate to the tooth of the saw blade.
Check if the distance is 19mm. The maximum position is 18mm.
7.5
Setting the cutting depth
When the cutting depth is not correct, it can be adjusted as following:
Move the motor base (14) as far as possible backwards
Loosen the Pin
Set the cutting depth by turning the screw, the screw is positioned at the back of the pin.
Repeat the procedure till the cutting depth is correct.
Fasten the Pin.
8 ASSEMBLY
ATTENTION! Disconnect the power plug before carrying out any
adjustments or maintenance..
8.1
Mounting saw blade
Loosen your screws and open the top of the base plate
Press the spindle lock and turn the spindle until it engages in the lock. Keep the spindle
lock pressed during this procedure.
