POWX0076LI
EN
Copyright © 2013 VARO
P a g e
|
8
www.varo.com
9.2
Adjusting the depth of cut (Fig. 2)
The depth of cut is infinitely adjustable. A clean cut is achieved with the saw blade protruding
from the material by approx. 3 mm.
Loosen the lock lever for depth adjustment (5).
Hold the base plate (10) flat against the edge of the work piece and lift the body of the saw
until the blade is at the right depth determined by the depth gauge (4) (align the scale
line).
Tighten the lock lever for depth adjustment.
9.3
Setting the mitre angle (Fig. 3)
The mitre angle is infinitely variable between 0° and 45°.
Loosen the lock lever for angle adjustment (9).
Adjust the shoe to the desired angle between 0°to 45°. [See Angle gauge (8)].
Tighten the lock lever for angle adjustment.
9.4
Mounting the parallel fence (Fig. 4)
The parallel fence allows sawing parallel to an edge at a maximum distance of 10 cm.
Loosen the adjustment screw of guide bar (11).
Slide the guide bar (12) through the slots in the base plate to the desired width.
Tighten the adjusting screw to secure it in the position.
Ensure that the guide bar rests against the wood along its entire length to give consistent
parallel cuts.
10 OPERATION
10.1
Instructions for use
Clamp the workpiece. Make sure that the side which will be visible later is facing down,
because the cut is most accurate at that side.
Switch on the machine before it touches the workpiece. Do not exert pressure on the saw
blade. Allow the machine enough time to cut the workpiece.
Hold the machine with both hands using both grips. This ensures optimum control over the
machine.
For straight cuts along a drawn line use the marking for straight cuts.
For bevel cuts along a drawn line use the marking for bevel cuts.
10.2
Switching on and off (Fig. 5)
To switch the tool on, keep the lock-off button (2) depressed and press the on/off switch
(1).
To switch the tool off, release the on/off switch.
10.3
Dust extraction
A vacuum cleaner can be connected to the dust extraction outlet, either directly to the
connector or using an adapter.
If necessary, connect an adapter to the extraction outlet.
10.4
Laser beam
The laser beam is used for projection of the cut on the workpiece.
Switch the laser (14) on by means of the laser on/off switch (13).
Place the machine on the workpiece with the saw marking above the start of the cutting
line.
Check that the laser line aligns with the cutting line as marked on the workpiece.
Switch on the machine.
Follow the “instructions for use” to perform a cut.
After use , switch off the laser.
