Form code: TA 251
Revision: 2020-02
Page 4 of
4
Job Id:
262.1-034406-1
Certificate No:
TAM000017G
Hub-30_VP64-03
05a
Hub-30 VP-64
AP Approved
Hub-30_VP76-02
04a
Hub-30 VP-76
AP Approved
Hub-45_VP104-02
02/GL
Hub-45 VP-104
AP Approved
Kappe DF-380-00
01
Kappe DF-380
FI For Inf.
Nabe DF-380-01
01
Nabe DF-380
AP Approved
NabeDF112-02
04
Nabe DF-112
AP Approved
PropNut DF-380-00
00
Prop.-Nut DF-380
FI For Inf.
Puller DF-380-00
00
Abzieher f. DF-380
DI Discarded**
VP104_Flg-20-01_flat
2009-02-11 Blade VP-104 20"
AP Approved
VP104_Flg-26-01_flat
2009-04-15 Blade VP-104 26"
AP Approved
VP64_Flg-13-03_flat
2008-05-16 Blade VP-64 13"
AP Approved
VP64_Flg-18-03_flat
2008-05-16 Blade VP-64 18"
AP Approved
VP76_Flg-17-01_flat
2008-06-10 Blade VP-76 17"
AP Approved
VP76_Flg-22-01_flat
2008-06-25 Blade VP-76 22"
AP Approved
Tests carried out
None.
Marking of product
Manufacturer’s name or trademark. Type number designation.
Periodical assessment
For retention of the Type Approval, a DNV GL surveyor shall perform an assessment after 2 years and
after 3.5 years to verify that the conditions of the type approval are complied with. A renewal
assessment will be performed at renewal of the certificate.
The objective of the Periodical Assessment is to verify that the conditions for the Type Approval are not
altered since the Type Approval Certificate was issued. The main scope of the Periodical Assessment will
normally include:
Verification of the Type Approval applicant’s production and quality system w.r.t. ensuring
continued consistent production of the Type Approved products at the Type Approval applicant’s
own premises and at other companies that are given the responsibility for manufacturing of the
products
Review of the Type Approval documentation and that this is still used as basis for the production
Review of possible changes to the design, the material and the performance of the product
Verification of the product marking
In cases where the Type Approved product is manufactured at other companies, the Periodical
Assessment shall verify that the Type Approval applicant has a quality control system for consistent
production at their licensees/subcontractors. Furthermore Periodical Assessment shall be carried out
randomly at these companies.
When a Type Approved product is manufactured at other companies, the Type Approval applicant takes
the sole responsibility for the conformity of the product to the applicable requirements.
END OF CERTIFICATE.
F82 VP DF190 Installation Instruction Rev 10.pdf
Stand:02/02/2023
15
