Page 13
CHAPTER 2 - INSTALLATION
2.7 POWERING UP
Before powering up the MST-5, attach the faceplate to the
casing of the MST-5 using the six screws previously
removed.
Set Selector knob to position (12).
Upon powering up, the unit will test it’s display by briefly
lighting all the segments of it’s LED display. Make sure
that all segments light up.
Following the LED display test, the unit displays the room
temperature.
If the temperature is not displayed, refer to the Trouble
Shooting section in the appendix of this manual.
Fig. 1
Wiring diagram for 3 single speed fans and 2 heating units.
www.monitrol.com
Summary of Contents for MST-5
