Page 10
ECS 1M
2.2 MOUNTING
Mount the control panel to the wall using the mounting
holes located on the flange of the control housing
Once the ECS 1M is in place, use a screwdriver to
remove the six screws holding the faceplate to the
housing.
2.3 SWITCH SETTINGS
The ECS 1M is configured for a variety of options via two
switches as follows:
2.3.1 - Line Voltage Selector Switch
This switch is located on the surface of the main (bottom)
board and adapts the control panel for 115 VAC or 230
VAC line voltage.
Refer to Figures 1, and 2.
To limit the unit’s exposure to noxious gases install the
unit in a hallway.
Make certain that the unit is mounted right side up with
the cable entry holes facing down.
The ECS 1M will operate in a temperature range of 32°F -
120 °F (0 °C - 50 °C).
* It is prohibited to use overhead cables outside the building.
Mounting hardware is not shipped with the unit.
230V
115V
www.monitrol.com
