Vari Hurricane F-550, User Manual

Page: 31 / 38

F-550
2.7 Picture appendix
The picture appendix is common for all the language versions. You can find it at the end of this manual in the Chapter 3 on page 35 .
1) Tilted handlebars in package (position for transport)
2) Bag with manuals
3) Disassembled frame with spur
4) Rear grasping area (“U” tube of frame)
5) Centre grasping area
6) Paper insert of operating space
7) Paper insert below handlebars
1) Screw connection - Nut
2) Tab
3) Screw connection - Screw
4) Groove in frame
5) Spur arm
Fig. 1: Unwrapping the machine Fig. 2: Assembling the machine
See the picture at the chapter 3 .
1) Drive clutch lever of the work tool
2) Wheel drive clutch lever
3) Handlebar fastening screw
4) Throttle lever
5) Spur with arm
6) Safety circlip pin
7) Work tool = blade
8) Operating space shroud
9) Front cover
10) Gearbox cover
11) Machine frame
12) Handle
13) Engine
14) Fuel cap
15) Tyre
16) Safety stop button
17) Clip with cables
18) Engine plate Fig. 3: Main parts description
1 STOP :
The engine is off.

Used for turning off a started engine

Putting aside the machine

Fuel refilling

Machine transport
See the picture at the chapter 3 .
Fig. 4: Accelerator lever positions
2 MIN :
Engine runs in neutral rpms. (turtle position)

Short-term work rest
3 MAX :
Engine is running at maximum rpm. (hare
position)

Operating position
4 CHOKE :
Engine runs on choke.

Engine cold start
See the picture at the chapter 3 .
1) Nuts
2) Blade carrier
3) Work tool - blade
4) Screw
5) Center screw
1) Gearbox cover
2) Bottom gearbox cover
3) Plastic nut
4) Foot / tab
Fig. 5: Cutting width Fig. 6: Work tool mounting Fig. 7: Rear covers
Fig. 8: Cutting height Fig. 9: Higher speed Fig. 10: Lower speed
Fig. 11: Drive clutch and brake Fig. 12: Bowden cable adjustment I Fig. 13: Wheel drive clutch
Fig. 14: Bowden cable adjustment II Fig. 15: Gearbox belt
Fig. 16: Belt route
<<< Position on machine
Fig. 17: Sticker – Forbidden Area
Fig. Chyba: zdroj odkazu nenalezen: Combined sticker
Position on machine >>>
Fig. 18: Sticker – direction of turning
Position on machine >>>
Fig. 20: Sticker
Position on machine >>>
Fig. 21: Sticker
Fig. 22: Sticker – speed selection
31
05
/2
01
2