Vari BDR-595 E EuroAdela, Instructions For Use Manual, Page: 16 / 39

BDR-595 E EuroAdela
16
ground and does not rebound. Disk rebounding results in uneven stand mowing
6.6.2 Mowing grass stands
Set the engine to maximum speed, let the mowing disk rotate at maximum speed
(starting the mowing disk see chapter 6.3 ) and get the machine into motion ( see chapter 6.4 )
facing the stand to be cut. The mown grass is thrown away by the mowing disk to the right
side onto the screen which forms a swath. Grass leaves the space under the screen from in
front of the right wheel.
The only correct way how to proceed at cutting the grass stand is to have the to-
be-mown grass at all times on the left side of the machine (see Figure).
It is adviseable to drive the machine along the slope contour lines for cutting.
Keep in mind, however, that the maximum machine tilt permitted is 20° (long-term)
and 30° (short-term)!
If the stand is very dense, grown through, rotten or lodged, the machine working
engagement width must be reduced accordingly so that the mowing disk rotations are not
being excessively reduced and the cutting quality impaired.
6.6.3 Problems at cutting
Choking of the space under the upper casing and apron with grass can show as follows:
a) Engine markedly loosing speed but not stalling: machine travel to be switched off
immediately (lever on the left handrail); drive in reverse gear just a bit with a
simultaneous slight lifting of the machine front (by pushing down on the handlebar
handrails). The casing space will do itself a partial clearance of excessive grass matter.
Then drive the machine against the stand again (
see chapter 6.4 ).
,
Be very careful while lifting the machine and at reverse driving!
b) Engine loosing speed and stalling: release the both levers on the handlebars, lift the
machine front part by pushing down on the handlebars and drive a bit in reverse. Clear
the space under the upper casing and spread the cut grass across the ground. Start the
engine, switch on the mowing disk drive (
see chapter 6.3 ) and once again drive the
machine against the stand ( see chapter 6.4 ).
,
The engine must always be switched off when clearing the space under the upper
casing and screen!
,
Tilt the machine always only backwards onto the handlebars. Be very careful while
moving in the space beneath the lifted machine! Secure the machine against
spontaneous motion!
,
Be very careful while cleaning the space under the upper casing and screen. Cutting
edges of knives are sharp. You should wear protective gloves or you can also use a
piece of branch etc.