3
VL800 EVENTPROFILE
QUICK START GUIDE
HANGING THE LUMINAIRE
The VL800 EVENTPROFILE Luminaire can be hung hori-
zontally or vertically from any structure designed to work
with the type of load created Clamp and Quick lock fasten-
er or other mounting hardware are required. Many compat-
ible truss hooks are available from diff erent manufacturers
for your particular needs.
One Quick-lock fastener per luminaire is required. If
mounting method does not use truss hooks, two attach-
ment points per luminaire, are required. Always ensure
the diameter of safety cable is at least 4 mm, which can
support at least 12 times the weight of the unit.
To install mounting hardware and brackets:
Step 1.
Bolt each clamp to the Omega holder with screw
and lock nut through the hole in the holder as shown in
FIGURE 3
.
NOTE:
Various types of truss hooks can be used. The Clamp (as shown) as well as many other standard hooks,
can be ordered separately.
Step 2.
Faster the omega holders on the bottom of the base by inserting quick-lock fasteners into the holes of
the base and tighten fully clockwise.
Step 3.
Hang the fi xture to the support through clamp and faster the screws, faster the safety cable through
the bottom of the base and over the support.
WARNING!
Ensure that the bracket locking mechanism is fully seated after the bracket is installed on the
luminaire.
FIGURE 3.
INSTALLING BRACKETS ON LUMINAIRE ENCLOSURE
To install luminaire in truss:
Step 1.
Lift luminaire into mounting position.
Step 2.
Secure in place with clamp handle. Ensure clamp handle hardware that Quick-lock fastener hook in
place (eg. wing bolt) is properly tightened and that luminaire is fully supported.
Step 3.
Attach safety cable (as required) as follows (refer to
FIGURE 4
):
a.
Loop safety cable at least once around safety cable anchor point rod.
b.
Loop safety cable at least once around truss/pipe and secure around pipe.
SAFETY CABLE:
Recommended for hanging installations. May be required by local codes. Safety cable sold
separately.
NOTE:
Truss hooks shown are sold separately. Truss and pipe by others.
Step 4.
Make sure hanger is disengaged so luminaire moves freely.
Step 5.
Connect power and data cables.
