20
21
Regulations
All local regulations, including those that refer to national and European standards,
must be complied with during fi tting, e.g. the Danish building regulations for small
houses, BR-S 98, published by the National Agency for Enterprise and Construction.
Minimum distance to combustible materials, such as fl oors, walls or furniture
Varde In-Line 55: Behind: 35 cm Side: 35 cm Above the fl oor: 30 cm In front: 110 cm
Floor materials
If there is a fl oor made of combustible material by the fi replace insert, this must
naturally be covered by a panel of non-combustible material such as a steel plate,
glass sheet, Dutch brick or artifi cial slate. The fl oor panel must extend at least 15
cm from the sides of the insert and at least 30 cm from the front. We recommend
however 50 cm at the front.
Fresh air intake
A supply of fresh air must be available in the room in which you install the fi replace
insert, e.g. via ventilation grills in the walls. It must not be possible to block these
grills. You should also be aware that any extraction ventilators (cooker hoods or the
like) in the same room as the insert may cause problems in relation to the chimney
updraught.
Damper
In some cases it may be necessary to install a damper in the chimney, so that the
updraught can be adjusted. This can be especially useful on very windy days. There
must always be at least 20 cm
2
of free passage via the chimney. Consult your dealer
or chimney sweep for advice.
The fi replace insert is suitable for connection to a fl ue gas collector.
Always ensure that the fl ue gas connector and chimney can be cleaned. Consult
your dealer or chimney sweep for advice.
Nominal operation and a room temperature of 20˚C provides:
Varde In-Line 55: Smoke mass fl ow: 6.8 g/sec Flue gas temperature: 274°C
Important information
DANSK
|
ENGLISH
|
DEUTSCH
|
FRANÇAIS
VARDE IN-LINE 55
|
Nominal heat output: 7 kW (4-9 kW)
|
Heats up to: 30-100 m
2
|
Weight: 102 kg
|
Smoke outlet: Ø 15 cm
|
Exterior dimensions: height 54.5 x width 68 x depth 37 cm
|
Exterior dimensions of front frame: height 71.5 x width 79.5 cm
Specifi cations
APERTURE DIMENSIONS FOR
STANDARD FRAMES:
Height: See the sketches under
“Building in*”
Width: 70-75 cm
Depth: Min. 40 cm
D
B
H
