•
Connect as shown above
•
•••
Foot
Foot
Foot
Foot Pedal
Pedal
Pedal
Pedal Switch
Switch
Switch
Switch must
must
must
must be
be
be
be set
set
set
set to
to
to
to OFF
OFF
OFF
OFF
•
If your machine has the air pressure gauge in the front, then there will be two
outputs on the air regulator. One output will go for the air pressure gauge,
while the second output will go into the brass nozzle on the back of the machine
with a hose.
•
Connect the torch to the front of the machine
•
Connect the ground clamp to the front of the machine
•
Selector Switch should be set to CUT (Down Position)
•
Current is adjustable 10-50A
MAINTENANCE
MAINTENANCE
MAINTENANCE
MAINTENANCE
•
Each Use
o
With the power turned off. Before and after each use inspect the
machine and its torch.
o
Replace or repair any worn part prior to use.
o
A worn out tip is characterized by an oversized or elongated orifice.
o
If the electrode is recessed greater than 1/8” it should be replaced.
o
If the shield cup is not able to be put on easily it may need to be
replaced.
•
On a weekly basis the machine should be blown out for dust
