Vaporfi VEX 150 TC, Manual

Page: 3 / 17

3
USING DEVICE:
TEMPERATURE CONTROL:
To turn on the VEX 150w TC mod, insert batteries then press the power button five
times, you will do the same to turn off the device as well. Before using the device,
make sure you are in the correct mode depending on the atomizer you are using. To
adjust modes, press the power button three times to enter the designated menu.
Once there, use the – button the navigate the menu and the + button to make any
necessary changes. Once you’ve checked your settings, you are now ready to vape.
Hold the power button while inhaling from the drip tip, releasing the power button
once the desired vapor production is achieved. Use the + and – buttons to determine
the best wattage or temperature, depending on your atomizer, that works for your
vaping style.
If you are planning to use an atomizer in one of three temperature modes, press the
power button 3 times to enter the designated menu. Once in the menu, press the –
button, you will notice that the modes will begin to flash. Now, press the + button to
scroll through the different modes. Once you have found the correct mode for your
atomizer, you are now ready to vape in temperature control mode. Using the + and –
Note: When the power button is held for longer than 10 seconds, the device will no
longer fire and the screen will display, “Over 10s Protection.”
www.vaporfi.com
When replacing your atomizer, especially from a nickel atomizer to a temperature
controlled atomizer (Ni, Ti, SS 316), you will be required to reset the resistance of that
buttons you can adjust your temperature (ranges from 100-315 degrees Celsius to
200-600 degrees Fahrenheit) to find the best temperature for your e-liquid.
atomizer. This helps the device recognize that the new atomizer is to be used at room
temperature, which ensures that you will not experience a burnt hit, if properly
primed. When prompted press the + button to indicate that the replacement atomizer
is new. If you are using the same atomizer and are prompted, press the – button
indicating that the atomizer is the same.