6
4-1
Master Vapac
Used to select the “master” Vapac status parameters to be displayed
4-1-1
Unit
Used to select “unit” parameters.
4-1-2
Cylinder 1
Used to select “cylinder 1” parameters.
4-1-3
Cylinder 2 (if fitted)
Used to select “cylinder 2” parameters (this option will only be displayed if
the “master unit has two cylinders).
4-2
Slave Vapac 1 (if fitted)
Used to select the first slave Vapac (this will only be displayed if there is a
slave unit on the system) in which case 3-2-1 will again be “unit” properties
and 3-2-2 “cylinder 1 “ properties etc…. NB if additional slaves are fitted 3-3
(slave 2) and 3-4 (slave 3) etc will be displayed if necessary.
4-1-1-1
Unit capacity
Displays the maximum steam output of the unit, in addition to if the unit is
derated either via UCP1 or `Rated Output’
3-1-1-15
Master/Slave
This displays information on the operation of master/slave systems. It can
be used to verify and/or diagnose master/slave operation
3-1-2-1
Mode
Displays the cylinder mode (Shutdown/Standby/Online/Manual drain in
progress/complete)
3-1-2-2
Demand
Displays the cylinder demand (for single cylinder units this will equal unit
demand
3-1-2-3
Not available at this level
This option will not be displayed the next available menu item being
displayed will be 3-1-2-4)
3-1-2-4
Hours run
Displays the total number of hour that the cylinder has been on line. (this
can be reset at Service engineer’s level)
3-1-2-5
Steam output
Displays the actual steam output of the cylinder
3-1-2-6
Current
Displays the unit demand level as a percentage.
3-1-2-7
Max current
Displays the normal maximum current that will flow in the cylinder at full
output.
3-1-2-8
Actual Voltage
Displays the actual voltage being applied to the electrodes control the unit.
3-1-2-9
Power Input
Displays the actual input power to the cylinder
3-1-2-10
Consumption
Displays the average power consumed by the cylinder
3-1-2-11
Total Power Used
Displays the total power consumed by the cylinder
3-1-2-12
Fault Totals
Displays the total number of faults that have occurred on the cylinder
3-1-2-13 Demand
Runhours
(Version 7.4.2 controller)
Displays the run hours for 4 bands of cylinder demand
3-1-3-1 to 3-1-3-15
Cylinder status repeated for cylinder 2 if applicable
3-2-1 to 3-10-3-13
Unit & cylinder status repeated for slave units 1 to 9 (depending on the
network configuration
LE 7.4
4
Status
Info
